Fixing a loose or rattling Corsair Survivor flash drive

By , November 25, 2013 11:53 am

Note: I’d originally included the Corsair Stealth, as I thought they were the same, just a different color.  I’ve gotten feedback that they’re different.  If you have a Stealth with the same problem and figure out how to fix it, shoot me some feedback on how it’s different, or send me a link I can provide in case anyone else has the same issue.

My USB memory stick of choice right now is a Corsair Survivor USB 3.0 stick.  It’s nearly indestructible when it’s all buttoned up!   Unfortunately, that’s not entirely true when it’s out of it’s little protective shell.

After a couple weeks of using the Survivor, I noticed that it was rattling whenever I shook or dropped it.  After using it for a few weeks weeks, I noticed that it was “wobbly” when it wasn’t in it’s little shell.  It turns out the the drive itself is just screwed onto the casing.  Those screws can get loose.  When they do, expect the rattles!  Here’s what it looks like and how to fix it.

If you can “bend” the device and it has a little space at the bottom, near the activity light and the threads, yours’ is probably loose.  I’ve included pictures of mine bending both ways.

Note the gap next above the threads on the left side.

Note the gap next above the threads on the left side.

There's a gap on the right here.  The "stick" wobbles back and forth on the base.

There’s a gap on the right here. The “stick” wobbles back and forth on the base.

Turn it over and gently peel back the existing sticker on the back.  Use something sharp to get under it without damaging it (don’t cut yourself).

Use something thin and sharp to get under the back label.

Use something thin and sharp to get under the back label.

Lift it up about a 1/2 inch or so and you’ll find two small phillips-head screws under it.  Use a very small set of screwdrivers to tighten them back down.  It’s probably not a bad idea to pull them out (one at a time) and hit them with some threadlocker.

Tighten the two small Philips screws under the label.  If you've got the time, use some threadlock compound so you don't have to do this again in a week or so. :)

Tighten the two small Philips screws under the label. If you’ve got the time, use some threadlock compound so you don’t have to do this again in a week or so. 🙂

Boom!  Snug as a drive in shell! 🙂

Be Sociable, Share!

10 Responses to “Fixing a loose or rattling Corsair Survivor flash drive”

  1. Anon. says:

    Hm.

    Screws must not be in the same place on the Survivor Stealth.

  2. Jonathan says:

    Thanks, noted. If you find out how they’re different, let me know so I can update that.

    • Anon says:

      Hm. In place of the screws on the stealth it seems it has some type of clip. Doesn’t look like anything can be done with it. Whatever it is (the tiny clip thing) it doesn’t look like it is connected to the actual flash storage part of the drive as it doesn’t move when I move the USB part back and forth. Also I can feel nothing on the front (led) side of it but is still possible screws are under it. Will check in a couple of days. If no reply within a week just assume I found nothing. Also I know there are no screws under the rubber protective parts (2). I can’t see how there would be screws anywhere else as no other parts seem removable.

      Will post a pic if it ever gets done uploading…

  3. Ulver says:

    Everything is the same on my 32GB Survivor Stealth. Thank you very much, fixed it in a few seconds 🙂

Leave a Reply

Panorama Theme by Themocracy